3. At vehicle cargo bed, remove tie down rings (three in rear, two forward in between front seats) and any other
hardware that may be attached to floor or fender wells and store with Organizational Maintenance. Floor and
fender wells should be clean and free of all appendages, dirt and corrosion. Remove plywood insulation
between rear seats if it has been previously installed (Figure 2).
Figure 2. Cargo Bed Area
4. At rear of vehicle cab, remove and retain rear cab curtain and associated hardware as per instructions
contained in TM 9-2320-280-10 and store with Organizational Maintenance.
1. Follow procedures identified in WP 0020 00, SECM Assembly of Major Components.
End Of Work Package